DVD Processing Instructions – Feb 2020

Use this DVD as an example when you process the DVDs in the back room.

1. Target the outside spine of the case – black cases get ½ target (centered in middle); clear cases get whole target (centered down spine, do not start at top of case). NOTE: For CLEAR cases: If back of jacket is plain white, put full target on spine portion of paper jacket. If back of jacket has info/pictures on it, place full target on outer side of case spine (target will show thru – that’s okay).

2. Ownership label on inside material (sheet, leaflet [folded], or booklet [staples]) – upper right corner. If material is not glossy finish, you can use SMALL stamp instead.

3. Ownership on disc/s – using special pen, write UMA on bottom of inner circle; if more than 1 disc, write disc 1/#, 2/#, etc. (# = total discs in case). *** DO NOT write on any part of disc if it is double-sided; can only write on CLEAR part of inner circle. (When in doubt, you can leave them for me to do).

4. Contents label on front of case – upper left corner below the barcode.

5. Call # labels – (min. of 2 per case PLUS [if needed] any additional for inside contents).

Cut off excess blank bottom of each label.

REGULAR CASE – 1 call # label on front of case in upper right corner.

                                            – 1 call # label on spine (DO NOT cover catalog #s).  
                                            –  Place clear label protector tape over spine call # label only.

THIN CASE – 1 call # label on front of case in upper right corner.

                                     – 1 call # label on bottom left corner.  (NO tape on this one.) 

Additional material – only 1 call # label on each additional material inside case (sheet, leaflet, booklet) – upper left corner (or wherever it will fit without covering any info).

6. If PAL/Region 2 dvd add additional label.